Filter
Top Products
18
5-5 FRONT BELTING INSTALLATION
A. Align belting and clamp with holes in front lip
of deck.
B. Fasten with 3/8 x 3-1/2” capscrews, flatwash-
ers, lockwashers and nuts. (Figure 5-4)
5-6 REAR BAND INSTALLATION
A. Align deflector band with holes in rear band of
deck.
B. Fasten with 3/8 x 1” capscrews, flatwashers,
lockwashers and nuts. (Figure 5-4)
5-7 FRONT CHAIN INSTALLATION
A. Align front chain assembly bracket with holes
in front lip of deck.
B. Fasten with 3/8 x 3” capscrews, flatwashers,
lockwashers and nuts. (Figure 5-5)
5-8 REAR CHAIN INSTALLATION
A. Align rear chain assembly bracket with holes
in rear band of deck.
B. Fasten with 3/8 x 1-1/4” capscrews, flatwash-
ers, lockwashers and nuts. (Figure 5-5)
CAUTION
USE ONLY FACTORY APPROVED CHAIN
GUARDS.
WARNING
FOR NON-AGRICULTURAL USE, OSHA,
ASAE, SAE AND ANSI STANDARDS
REQUIRE THE USE OF CHAIN GUARDS OR
OTHER PROTECTIVE GUARDS AT ALL
TIMES. BUSH HOG STRONGLY RECOM-
MENDS THE USE OF SUCH GUARDS FOR
AGRICULTURAL USES AS WELL, TO
REDUCE THE RISK OF PROPERTY DAM-
AGE, SERIOUS BODILY INJURY, OR EVEN
DEATH FROM OBJECTS THROWN OUT OR
FROM CONTACT WITH THE CUTTING
BLADES.
Figure 5-4
Rear Band
Belting Clamp Front Belting
Figure 5-5
Rear Mount Bracket
Retaining
Rod
Chains
Front Mount
Bracket
Chains
Retaining Rod
Figure 5-6 Clutch Shield
Shield Mount
Gearbox
Patched Capscrew and Flatwasher
Locknut should be tightened enough to
prevent rattling, but loose enough to allow
raising the shield.
Capscrew, (2) Flatwashers and Locknut