Filter
Top Products
SAFETY
2547 01/11 Safety Section 1-11
© 2011 Alamo Group Inc.
SAFETY
Never leave the Implement and Power Unit unattended while the Implement is in the raised
position. Accidental operation of a lifting lever or a hydraulic failure may cause the
implement to suddenly fall causing serious injury or possible death to anyone who might
inadvertently be under the Implement. Lower the implement carefully to the ground. Do not
put hands or feet under lifted components.
(SPU-3)
The center of gravity of a Power Unit equipped with a front-mounted Implement is shifted to
the front and removes weight from the rear wheels. The Power Unit should maintain at
least 25% total weight with the maximum load in the bucket or attachment on the rear
wheels to prevent tipping forward, loss of steering control, and possible injury. Add
counterweight if required when operating on slopes and proceed with the load uphill to
prevent tipping. Reference the Power Unit’s Operator’s Manual or an authorized dealer for
information on adding additional weight.
(SL-37)
Make sure the hydraulic quick disconnects are fully seated into the connections. Do not use
the loader if the hydraulic connection is leaking. Leaking oil could allow the loader to fall
resulting in a serious crushing injury.
(SL-22)
If the loader valve controls fail to functions properly discontinue use of the tractor and
loader until the controls are properly repaired. Sudden or unexpected movement or
dropping of the loader and attachment could result in serious injury.
(SL-31)
Make sure all air is purged from the hydraulic system before using the loader. Air in the
system can cause the loader to respond sluggishly or with unexpected movement. The air
can be purged from the cylinder lines by fully cycling the cylinders several times from the
fully closed to fully open position. Sudden or unexpected movement or dropping of the
loader and attachment could result in serious injury.
(SL-32)