Filter
Top Products
OPERATION
2297 01/11 Operation Section 4-31
© 2011 Alamo Group Inc.
OPERATION
Make additional passes until desired depth is
reached. During each pass, use only bucket control
while working depth. This will allow you to
concentrate on controlling bucket angle to maintain
a precise cut.
LOADING LOW TRUCKS OR SPREADERS FROM A PILE
For faster loading, minimize angle of turn and
length of run between pile and spreader. Back
grade occasionally with a loaded bucket to keep
working surface free of ruts and holes. Also, hold lift
control forward so full weight of bucket is scraping
ground.
Do not roll bucket over and attempt to backgrade.
This type of use can cause severe overloading of
bucket cylinders when fully extended, possibly
causing bucket cylinder rods to become bent.