Filter
Top Products
SAFETY
1947/2047 01/11 Safety Section 1-9
© 2011 Alamo Group Inc.
SAFETY
Use extreme care when loading, transporting or dumping loads that impair or partially block
the operator’s line of sight. Know where you are traveling. Make sure no bystanders are in
the area of travel. If a bystander assists in providing guidance, make sure they are not in the
path of travel. Keep all bystanders 25 feet away from travel path.
(SL-29)
Always look behind you before backing up. Make sure you are looking
in the direction of travel. A bystander could walk behind the tractor.
Running into a bystander can result in serious injury or death.
(SL-30)
Some tractors are equipped with a “Super Steer” front axle. When a
loader is mounted to this type of tractor, the bucket will shift in the
opposite direction from which the wheels are turned. Maximum shift will
be approximately 8 inches and most noticeable when the tractor is
stationary. Sudden or unexpected movement of the loader and
attachment could result in serious injury to the operator or bystanders.
(SL-33)
Operate the tractor and loader only in conditions where you have clear visibility in daylight
or with adequate artificial lighting. Never operate in darkness or foggy conditions where you
cannot clearly see at least 100 feet in front and to the sides of the tractor. Make sure you
can clearly see bystanders, ditches, steep slopes, drop-offs, overhead obstructions, power
lines, and debris or obstruction in the travel path. If you are unable to clearly see these
types of items discontinue operating. Contact with unseen vehicles, bystanders,
obstructions, or drop-offs can cause serious injury.
(SL-35)
Be particularly careful in transport. The Implement has raised and moved the center of
gravity to the front of the Power Unit increasing the possibility of overturn and tipping
forward. Turn curves or go up slopes only at low speed and using a gradual turning angle.
Go up slopes with the Implement located uphill. Slow down on rough or uneven surfaces.
(SPU-2)
Never leave the Implement and Power Unit unattended while the Implement is in the raised
position. Accidental operation of a lifting lever or a hydraulic failure may cause the
implement to suddenly fall causing serious injury or possible death to anyone who might
inadvertently be under the Implement. Lower the implement carefully to the ground. Do not
put hands or feet under lifted components.
(SPU-3)