Filter
Top Products
ASSEMBLY
1945 01/11 Assembly Section 3-7
© 2011 Alamo Group Inc.
ASSEMBLY
Attaching Pin on Bucket
Material bucket can be installed using tool ordinarily available.
1. Attach bucket to lift boom frame and cylinders
with four 1” pins, use two 3/8 shoulder bolts and
3/8 lock nuts at upper pin (bucket cylinder). Use
two 3/8 x 1.25 hex bolts, 3/8 jam nut, 3/8 flat
washer and 3/8 lock nut at lower pin. Position
bolt with head on inside of outer bucket ear.
Fasten bolt to ear using 3/8 jam nut. Install pin
so pin head is over jam nut and retain with 3/8
flat washer and 3/8 lock nut.
2. Install level indicator rod in level guide tube on
right bucket cylinder. Sandwich level indicator
rod angle between right inside bucket ear and
cylinder rod end.
3. Set bucket level on ground and adjust level
guide tube along bucket cylinder until end of
guide tube is flush with end of rod.
Assembling Quick Attach Device
Quick attach device can be installed using tools
ordinarily available.
Torque all hardware to specifications listed in loader
operator’s manual.
Shut off the tractor engine and engage the tractor
brakes during installation.
Only quick attach, skid steer compatible
attachments can be used with the quick attach
device. Pin on style attachments can be used on
the loader, but necessitate removal of the quick
attach device and relocation of the bucket level
indicator.
All references to left and right used in these
instructions are as they would appear to the
operator standing at the rear of the unit facing
forward.
1. Quick attach device is pre-assembled at the
factory.
2. Unband the quick attach device and wood
blocks. (Figure Asm-L-0012)