Filter
Top Products
ASSEMBLY
1945 01/11 Assembly Section 3-5
© 2011 Alamo Group Inc.
ASSEMBLY
Dismounting Loader
1. Locate tractor and loader on firm level ground.
2. With bucket raised above ground, tilt bucket
down approximately 30 degrees from level.
3. Lower boom by retracting lift cylinders to lift
tractor front end (tires can be off ground).
4. Stop engine. Allow tractor front end to lower by
relaxing ONLY lift cylinders with control lever.
This will remove pressure on hitch pins (See
Figure Asm-L-0002).
Note: Do not relax bucket cylinders.
5. Set parking brake. Rotate parking stands from
storage position by removing linch pins and
clevis pins. Reinstall clevis pins and linch pins
when parking stands are in operation position
(See Figure Asm-L-0001).
6. Remove linch pins and 1” hitch pins from loader upright.
7. Start tractor engine and release brakes. Retract bucket cylinders to allow parking stands to contact ground.
8. Extend lift cylinders 6” to 8’ to rotate top of
loader uprights forward out of the mount,
allowing tractor to be pushed rearward.
Retract bucket cylinders until lower loader
upright pins clear mount pin saddles and front
tires (See Figure Asm-L-0003).
9. Move tractor rearward approximately 6”, being
certain not to stretch hydraulic hoses.
10. Stop tractor engine and set parking brake.
Relax lift cylinders and bucket cylinders by
moving each control lever in both directions.
Disconnect hydraulic hoses from tractor.
11. Start tractor engine and release brakes.
Slowly back tractor out of loader.