Filter
Top Products
3-74
435/485/535
Section 3 - Operation
Hydraulic Operation - Manual
N
L
H
M
R
N
F3-91
N
ON
STOP
F3-86
N
F3-87
Remote Control Valve Operation - Manual
Up to six remote hydraulic circuits are controlled by
levers located on the right console. These are color-
coded to match the quick couplers at the rear of the
tractor.
The colors are as follows: (from left to right), green (1)
blue (2), tan (3) and gray (4). (Optional - black (5),
white (6).
NOTE: Tractors with manual hydraulics are fitted with
either Standard Flow System (4 or 6 remote valves),
or High Flow System (6 remote valves). See page 3-82
for details.
The levers have four positions: neutral (7), extend
(raise) (8), retract (lower) (9) and float (10) as
indicated by the decals. When not in use, the levers
should be in the neutral position where they can be
locked to prevent accidental actuation.
For the extend position, the lever (1) is pulled toward
the operator. This is normally the implement raise
position. An adjustable pressure release detent will
hold the lever in the raised position until the cylinder
reaches the end of its travel, then release to the
neutral position. The lever lockout has no function in
this position.
1
2
3
4
5
6
10
9
7 8
1