Filter
Top Products
SBCN Abrasive Blast Cabinet Vertical Assembly & Operating Instructions
6
3. Align the four holes on any of the legs with the corresponding holes on cabinet.
4. Attach the leg to the cabinet by inserting a short screw with washer through the leg, then through cabinet,
and nut. Firmly tighten
nut. Repeat for all holes.
5. Repeat steps 3 and 4 for remaining legs.
6. Place screen frame into cabinet with flat edge of frame facing the bottom of cabinet.
Installing Cabinet Funnel and Shelf
1. Install the Abrasive Suction Pipe into the Cabinet Funnel, securing in place with 2 short screws, 2 washers,
2. and 2 nuts.
3. Place the open end of the Cabinet Funnel on top of the Screen Frame with Abrasive Suction Pipe towards
4. front of unit.
3. Align the holes in the lip of the Cabinet Funnel with holes in the Screen Frame and Cabinet.
4. Attach the Cabinet Funnel to the Screen Frame and Cabinet by inserting a long screw with washer through
each of the holes in
the Cabinet, Screen Frame and Cabinet Funnel. Place a nut onto end of each screw, and hand tighten nuts.
5. Attach the shelf to the legs by inserting a short screw with washer through each of the holes in the legs,
6. then through the shelf
and nut. Securely tighten nuts.
Final Assembly
1. Carefully stand unit upright.
2. Level unit on all four legs and then securely tighten all nuts.
3. Re-install Rubber Glove onto Mounting Ring and tighten in place with Clamp.
4. Open side door of Cabinet and place steel screen into place on Screen Frame. Steel Screw will
seat itself into recessed area of Screen Frame when it is properly aligned.
5. Secure plastic Abrasive Intake Hose to Abrasive Suction Pipe with the clamp provided. Tighten clamp securely.
6. Wrap the threads of the Air Hose Adapter with tape and place a Washer onto Air Hose Adapter. Insert the
threaded end
of the Air Hose Adapter through the Hose Inlet Fitting located on the front of the Cabinet. Place another Washer
onto threaded end
of Air Hose Adapter and then securely tighten the Air Adapter Nut onto threaded end of Air Hose Adapter.
Connect the air hose from
your air compressor the Air Adapter Nut.
You will need a Union fitting (sold separately) before you can connect your Blast Cabinet to an air compressor.
attach the Union fitting
to the Air Inlet and tighten the fitting. Attach a Quick Connect Set-Up (sold separately) to the Union fitting if
desired. This is a useful accessory as it allows quick-coupling
action when using a variety of tools with the same air compressor.
OPERATION
Always wear your hood, dust mask and heavy duty canvas gloves when operating the
abrasive blaster. Close and latch the door prior to operating the cabinet.
Before operating your abrasive blaster, inspect each connection, double checking to make
sure that all are tight and properly sealed.
THIS MACHINE IS NOT INTENDED FOR USE WITH SILICA BASED ABRASIVES. SILICA
BASED ABRASIVES HAVE BEEN LINKED TO SEVERE RESPIRATORY DISEASE. ALWAYS
USE SILICA SUBSTITUTES WHEN ABRASIVE BLASTING!