Filter
Top Products
SBCN Abrasive Blast Cabinet Vertical Assembly & Operating Instructions
5
SERVICE
Tool service must be performed only by qualified repair personnel. Service or maintenance by unqualified
personnel could result in a risk of injury.
When servicing a tool, use only identical replacement parts and follow instructions in the manual. Use
of unauthorized parts or failure to follow Maintenance Instructions may create a risk of shock or injury.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
This manual contains important information regarding safety, operation, maintenance and storage of this product.
Before use, read carefully and understand all warnings, cautions, instructions and labels. Failure to do so could
result in serious personal injury, property damage or even death.
IMPORTANT SAFETY INSTRUCTIONS
Before using this tool, you need to become familiar with its operation. If you are unsure about the
operation of the tool, or have any questions about its proper use, call the Customer Service Department
at 1-888-287-6981. Follow these instructions for safe handling of the tool:
• Close and latch the door before operating the Blast Cabinet.
• Check for damaged parts before use. Do not operate the Blast Cabinet if there are damaged parts.
• Maintain proper footing. Make sure you have secure footing and balance.
• Clean spills and sand abrasive in the work area.
SPECIFIC SAFETY RULES AND/OR SYMBOLS
SYMBOLS
The following symbols may be used on your tool. Be familiar with and learn the symbols to operate the tool safely.
Symbol
Name
Description
V
Volts
Voltage (Potential)
A
Amperes
Current
Hz
Hertz
Frequency (Cycles per Second)
W
Watt
Power
Kg
Kilograms
Weight
Alternating Current
Type of Current
Direct Current
Type of Current
Alternating or Direct Current
Type of Current
Earthing Terminal
Grounding Terminal
Class II Construction
Denotes Double Insulation
min
Minutes
Time
s
Seconds
Time
Diameter
Size of Drill Bits, Grinding Wheels, etc.
No Load Speed
No-load Rotational Speed
…/min
Revolutions per Minute
Revolutions, Surface Speed, Strokes, etc. per Minute
1,2,3…
Ring Selector Settings
Speed, Torque or Position Settings
ASSEMBLY
Be certain the Blast Cabinet is not connected to a power source before assembly. Plug the Blast
Cabinet into a power source only when assembly is complete.
Installing the Legs
1. Unpack the unit and place cabinet, with the viewing window face down, on a table.
2. Loosen the clamp which holds the glove opposite the door and remove glove from mounting ring.