Filter
Top Products
13. Move master ON/OFF switch (A) to the ON position
(turn knob fully clockwise).
14. Point gun in a safe direction, press trigger lock (red
button) and squeeze trigger. Pressure washer motor
will start and stop as spray gun trigger is depressed
and released.
The pressure washer is now ready for use. Instructions for
use of the supplied accessories are given later in this
section.
How to Stop Your Pressure Washer
The pressure washer motor runs only when the trigger is
engaged. To stop the pressure washer and turn off the
motor:
1. Release spray gun trigger.
2. Move unit’s master ON/OFF switch to OFF position.
IMPORTANT: Releasing the trigger will shut off the motor
but does not shut off electrical power to the unit.
3. Turn off water supply.
4. ALWAYS point spray gun in a safe direction, press
trigger lock (red button) and squeeze spray gun trigger
to relieve built up pressure in the unit.
NOTE: Spray gun traps high water pressure, even when
motor is stopped and water is disconnected.
5. Disconnect GFCI plug from outlet and coil power cord.
How to Use the Adjustable Nozzle
You should now know how to START and STOP your
pressure washer. The information in this section will tell you
how to adjust the spray pattern and to apply pressure
washer specific detergents.
1. Slide nozzle backward (B) to achieve high pressure.
Slide nozzle forward (C) when you wish to adjust spray
to low pressure mode.
2. Point nozzle down towards a firm surface and press
trigger to test pattern.
3. Twisting nozzle adjusts spray pattern from a fan pattern
(D) to a narrow pattern (E).
10 BRIGGSandSTRATTON.COM
D
E
B
C
A
WARNING
Risk of eye injury.
Spray can splash back or propel objects.
• Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction, press trigger lock
(red button) and squeeze spray gun trigger, to release high
pressure, every time you turn off motor.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER adjust spray pattern when spraying.
• NEVER put hands in front of nozzle to adjust spray pattern.