Filter
Top Products
22
www.SnapperPro.com
Operation
Executing an End-Of-Row Zero Turn
Your Zero Turn Rider’s unique ability to turn in
place allows you to turn around at the end of a
cutting row rather than having to stop and Y-turn
before starting a new row.
For example, to execute a left end-of row zero turn:
1. Slow down at the end of the row.
2. Move the RIGHT ground speed control lever
forward slightly while moving the LEFT ground
speed control lever back to center and then
slightly back from center.
3. Begin mowing forward again.
This technique turns the rider LEFT and slightly
overlaps the row just cut —eliminating the need
to back up and re-cut missed grass.
As you become more familiar and experienced
with operating the Zero Turn rider, you will
learn more maneuvers that will make your
mowing time easier and more enjoyable.
Remember, the more you practice, the
better your control of the Zero Turn will be!
Practice Turning Around a Corner
While traveling forward allow one handle to gradually return
back toward neutral. Repeat several times.
NOTE: To prevent pivoting directly on the tire tread,
it is best to keep both wheels going at least slightly
forward.
Figure 13. Turning Around a Corner
Figure 14. Turning in Place
Figure 15. Executing an End-Of-Row Turn
Practice Turning In Place
To turn in place, “Zero Turn,” gradually move one ground
speed control lever forward from neutral and one lever back
from neutral simultaneously. Repeat several times.
NOTE: Changing the amount each lever is pulled—
forward or back, changes the “pivot point” you turn
on.
Executing
Turns
Turning
In-Place
Not for
Reproduction