Filter
Top Products
12
E
G
D
B
Figure 14. Normal Installation & Removal
C
I
J
K
A
WARNING
OPERATION WITHOUT BAGGER
For operation without bagger, the mower
deflector MUST be properly installed in the
down position and retained by the spring latch.
H
F
D
C
L
Normal Removal
& Installation
L
A. Hitch Support
Assembly
B. Cover
C. Pin
D. Hair Pins
E. Bag
F. Grass Bag Hanger
G. Discharge Tube
H. Wire Form
I. Puck
J. Boot
K. Seal
L. Frame Spacers
Bagger Removal
1. Disconnect the discharge tube (G, Figure 14) from
boot (J) by moving wire form (H) up and out from
metal puck (I). Remove discharge tube (G) from
seal (K).
2. Remove hair pin clips (D) and pins (C) then
remove cover (B) see Figure 9.
Note: To prevent loss of parts reinstall pins (C) and
hair pins (D) in support assembly hinge pivots (E,
Figure 9).
3.Remove and empty bags (E, Figure 10).
4. Lift discharge deflector up (E, Figure 13).
5. Loosen (do not remove) wing nut (B) and lock nut
(C).
6. Slide lower chute (A) off carriage bolt (D) and
deflector hinge rod (F).