Filter
Top Products
16 BRIGGSandSTRATTON.COM
• To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black ProjectPro®
cleaning detergent nozzle.
4. Pull back on collar, insert new ProjectPro® nozzle and
release collar. Tug on ProjectPro® nozzle to make sure
it is securely in place.
Usage Tips
• For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
• If you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
• DO NOT get closer than 6 inches (15 cm) when
cleaning tires.
How to Use the Turbo Nozzle
The turbo nozzle spins a 0° nozzle stream in a circular
pattern, providing an intense wide-spray pattern for scouring
large surface areas fast and efficient.
A turbo nozzle can easily cut through heavy oil and grease
stains on concrete, brick and plastic and strip paint from
various surfaces. DO NOT use the turbo nozzle on delicate
materials, especially wood. Always start the turbo nozzle at a
distance, gradually getting closer to the surface until you get
the cleaning force you want. Always keep the turbo nozzle in
a constant motion. NEVER dwell on a single spot. Pass over
stubborn stains repeatedly until they are gone using even
strokes.
To attach the turbo nozzle to the nozzle extension:
1. Engage trigger lock on spray gun trigger.
2. Pull back collar on quick–connect and pull current
nozzle off. Store nozzles in holder provided on the
accessory tray.
3. Pull back on collar, insert turbo nozzle and release
collar. Tug on turbo nozzle to make sure it is securely
in place.
4. For most effective cleaning, keep turbo nozzle from 8 to
24 inches away from cleaning surface. If you get turbo
nozzle too close, you may damage cleaning surface.
NOTE: Detergent cannot be applied with the turbo nozzle.
Applying Detergent
To apply detergent, follow these steps:
1. Review use of ProjectPro® nozzles.
2. Prepare detergent solution as required by job.
3. Pour detergent into cleaning tank.
NOTE: The cleaning tank holds one gallon.
4. Make sure black detergent nozzle is installed.
NOTE: Detergent cannot be applied with the high pressure
ProjectPro® nozzle (Orange, Yellow or Red) or turbo nozzle.
5. Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump. Turn on water.
6. Engage trigger lock on spray gun and start engine
following instructions How to Start Your Pressure
Washer.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
The turbo nozzle produces an extremely high
pressure spray which is capable of removing
paint and cutting holes through surfaces if held
too close.
• Always make sure the surface you will clean will not be damaged
by the high pressure spray by testing in a hidden area.
CAUTION
Chemicals can cause bodily injury, and/or property
damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
NOTICE
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.