Filter
Top Products
15
How to Use ProjectPro® Nozzle System
The quick–connect on the nozzle extension allows you to
switch between four different ProjectPro® system nozzles.
ProjectPro® nozzles can be changed while pressure washer
is running once spray gun trigger lock is engaged. The
ProjectPro® nozzles vary the pressure and spray pattern as
shown.
Follow these instructions to change ProjectPro® nozzles:
1. Engage trigger lock on spray gun.
2. Pull back collar on quick–connect and pull current
ProjectPro® nozzles off. Store ProjectPro® nozzles in
holder provided on the accessory tray.
3. Select desired ProjectPro® nozzle:
• For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV’s, patio
furniture, lawn equipment, etc., select yellow
Delicate ProjectPro® nozzle.
• For general rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc., select orange
General ProjectPro® nozzle.
• For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains,
rust removal or other stubborn substances (tar,
gum, grease, wax, etc.), select red Max
ProjectPro® nozzle.
Delicate
40° Yellow
1750 PSI
2.3 GPM
General
15° Orange
2200 PSI
2.2 GPM
Max
0° Red
2550 PSI
2.0 GPM
Black
Use to apply
detergent
Low Pressure
High Pressure
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER exchange nozzles without locking the trigger lock on the
spray gun.
• DO NOT twist nozzles while spraying.