Briggs & Stratton 20258 Pressure Washer User Manual


 
CAT PUMPS WARRANTY
This pump is warranted by the manufacturer to be free from
defects in workmanship and material for ONE YEAR from
date of manufacturer’s shipment except:
FIVE YEARS for 2SF, 4SF and 66DX pumps and all
portable fresh water PRESSURE WASHER pumps.
TWO YEARS for 2DX, 3DX, 3SP and all CAR WASH
pumps except FIVE YEARS for 5CP2120W,
5CP2140WCS, 5CP2150W.
SIX MONTHS for 1LX and all rebuilt pumps.
90 DAYS on Accessories.
The sole responsibility for warranty on all motors is that of
their original manufacturers.
This warranty DOES NOT APPLY to malfunctions caused by
the FAULT or NEGLIGENCE of the buyer or third party,
including failure to perform periodic maintenance (oil, seal and
valve change), to the IMPROPER USE of the pump as a
component part, to failures reported to the manufacturer
AFTER the WARRANTY PERIOD has EXPIRED, or to the
NORMAL WEAR of standard wear items in the pump such as
V-packings, seals, cups, o-rings, valves, etc.
This express warranty is in substitution for and in lieu
of all other warranties, whether expressed or implied,
including, without limitation, any warranties or
merchantability or fitness for a particular purpose and
all such warranties are hereby disclaimed and excluded
by the manufacturer.
In order to take advantage of this warranty, you must first
contact your local CAT PUMPS supplier for a Return Goods
Authorization Number (763•780•5440, Fax 763•780•2958).
Any defective product must be returned FREIGHT PREPAID
to CAT PUMPS, 1681 94th Lane N.E., Minneapolis, MN 55449
(or international office of origin) for examination and
disposition. CAT PUMPS agrees to be responsible for return
shipping costs on any approved warranty repair or replacement
product with a carrier selected by CAT PUMPS. (Use original or
comparable carton to avoid damage in shipment.) The serial
number of the product will determine warranty date unless
original purchase invoice can be provided.
The buyer agrees that the sole and exclusive remedy in
law or in equity for breach of any and all warranties and
the sole and exclusive remedy for the manufacturer's
liability of any kind (including, without limitation,
liability for negligence) with respect to the product and
all other performance by the manufacturer will be
limited to the REPAIR OF, OR AT MANUFACTURER’S
OPTION,THE REPLACEMENT OF THE PRODUCT.
Buyer further agrees that manufacturer will, in no
event, have any responsibility or bear any liability for (a)
the cost of labor for the removal of any defective
product or the installation of any replacement product,
or (b) the cost of transportation to the manufacturer of
the defective products returned for evaluation. Finally,
buyer agrees that the manufacturer shall not be liable
for any other loss, damage or expense, including any
special, incidental or consequential loss or damage
(including, without limitation, lost profits), even if the
manufacturer has been advised of the possibility of such
potential loss or damage.
THIS WARRANTY IS SUBJECT TO THE FOLLOWING CONDITIONS:
SPECIFICATIONS: Pump operation must be within RPM, Discharge Pressure and Inlet Pressure specifications. A
pressure relief valve must be correctly installed in the system.
PUMPED LIQUIDS: The warranty is VOID if pump operation commences without sufficient liquid to the pump. Do not
pump harsh acids or alkalines or abrasive liquids. For pumped liquids below 5 pH or above 9 pH,
above 130°F, above 500 CPS (2500 SSU) or other questionable liquids, contact CAT PUMPS for additional
information on alternative construction and installation.
LUBRICATION: The use of Genuine CAT PUMPS special custom-blend, multi-viscosity, ISO-68 hydraulic oil is highly
recommended. WARNING: Use of alternate oils that do not provide proper lubrication will VOID
YOUR PUMP WARRANTY.The warranty is also VOID if pump operation commences without the
proper amount of oil in the crankcase, oil becomes contaminated or pump operates without
periodic oil changes as recommended. Fill Gearbox pumps with required lubricant before initial
start-up. Review individual service manual and data sheet for required amount of oil (lubricant) and
maintenance cycle.
TEMPERATURE: Protect pump from freezing. Do not store in area with freezing conditions. Drain completely of pumped
liquid. Flush with antifreeze. Do not operate pump which contains frozen liquid. Do not store or operate
in excessively high temperature areas or without proper ventilation.
USE OF OTHER THAN CAT PUMPS PARTS VOIDS THE WARRANTY
This supercedes any and all previous warranty statements.
2/06 Rev N