Filter
Top Products
Pressure Washer
6
4. Insert “L” bolt through hole on left side of handle
(viewing from rear of unit) and attach plastic knob.
Tighten knob by hand (Figure 3).
5. Insert carriage bolt through right side hole from
outside of unit and attach plastic knob from inside of
unit (viewing from rear of unit).Tighten by hand
(Figure 3).
6. Insert “J” hook into second from left slot in accessory
tray (Figure 4).
7. Pinch chemical hose and slide it into metal clip as
shown in Figure 5.
8. Tilt unit up by handle and attach metal clip to rib on
center underside of accessory tray (Figure 6). Slide
chemical hose through metal clip so that it is tight but
not kinked.
Figure 3 — Secure Handle
Figure 4 — Install “J” Hook on Accessory Tray
Figure 5 — Slide Chemical Hose into Metal Clip
Figure 6 — Slide Metal Clip onto Accessory Tray Flange