Filter
Top Products
HN200 Recess-Mounted Shower Warranty
Bradley Corporation warrants to commercial and institutional purchasers only each unit free from defects in
material and workmanship under normal use and service upon the following terms and conditions:
1. This warranty is limited to replacing or repairing, at our option, transportation charges prepaid by the
purchaser, any Bradley unit or part thereof which our inspection shall show to have been defective within
the limitations of this warranty.
2. The period during which HN200 Shower components are warranted is one (1) year, measured from the
date of our invoice.
3. This warranty does not cover installation or any other labor charges and does not apply to any units
which have been damaged by accident, abuse, improper installation or improper maintenance.
4. The replacement or repair of defective units as stated in this warranty shall constitute the sole remedy of
the purchaser and the sole liability of Bradley Corporation under this warranty. Bradley Corporation
shall not otherwise be liable under any circumstances for incidental, consequential or indirect damages
caused by defects in the repair or replacement thereof.
5. This warranty extends only to commercial and institutional purchasers and does not extend to any others,
including consumer customers of commercial and institutional purchasers.
6. This warranty is in lieu of all other warranties, express or implied, including any implied warranty of
merchantability or fitness for a particular purpose or otherwise.
ADA Compliant Recess-Mounted Shower
HN200 Installation Instructions
Bradley Corporation • 215-1189 Rev. F; EN 02-342
2
Pre-Installation Information
CAUTION: This shower system may not protect the user from scalding if other
temperature controlling devices in the plumbing system should fail.
CAUTION: Excessive heat to the Equa-Flo™ valve body will damage its internal
parts.
Overview
The Bradley ADA compliant HN200 comes assembled for job site installation. When installed in a
36" x 36" stall, the HN200 provides a shower which meets ADA accessibility codes. Check local
codes for dimensional compliance.
Components
Face Plate Material: The shower control panel is constructed of stainless steel.
Valve and Component Material: All exposed parts (except seat cover) are stainless steel or
polished chrome-plated brass. Valve bodies are brass casting.
Barrier-Free Seat: Folding shower seat is constructed of molded plastic with a load capacity of
250 lbs.
Shower Curtain: Vinyl shower curtain comes with stainless steel curtain rod and hooks.
Supplies required for installation:
• 1/2" NPT hot and cold or 1/2" NPT tempered water supplies
• (12) 1/4" wall anchors and 1/4”-20 x 3/4” screws to install shower face plate
assembly to wall
• (6) wall anchors for 1/4-20" x 1-1/4" hex socket screws to install grab bar (grab
bar is designed to sustain a concentrated load of 300 pounds)
• (7) wall anchors for 1/4 x 1/2" Type AB sheet metal screws to mount shower seat