Filter
Top Products
Clean the exterior of the machine thoroughly using a
soft brush and cloth. Do not use water, solvents or
polishes. Remove all grass and debris, especially
from the ventilation slots 9.
Using a soft brush clean the grass comb 11 remov-
ing any grass and debris.
Turn the machine on its side and clean the blade
area. If grass cuttings are compacted in the blade
area, remove with a wooden or plastic implement.
Always wear gardening gloves when han-
dling or working near the sharp blade.
Store the machine in a dry place. Do not place other
objects on top of the machine.
To aid storage loosen the wing nuts 14 and fold the
handles.
☞
Ensure cables are not trapped when folding/
unfolding top handles, do not drop the han-
dles.
Blade
ROTAK 34..........................................F016 800 271
ROTAK 36..........................................F016 800 275
ROTAK 40..........................................F016 800 273
ROTAK 43..........................................F016 800 274
The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off and remove plug from mains before investigating fault.
After Mowing/Storage Accessory
Fault Finding
Symptom Possible Cause Remedy
Machine fails to operate Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Mower in long grass
Motor protector has activated
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace fuse
Increase height of cut and tilt mower
Allow to cool and increase height of
cut
Machine functions
intermittently
Extension cable damaged
Machines internal wiring damaged
Motor protector has activated
Inspect cable, replace if damaged
Contact Service Agent
Allow to cool and increase height of
cut
Machine leaves ragged
finish
or
motor labours
Height of cut too low
Cutting blade blunt
Underside of machine badly clogged
Blade fitted upside down
Increase height of cut (see “Height of
Cut Adjustment”)
Replace blade
(see “Blade Maintenance”)
Clean machine (see “After Mowing/
Storage”)
Refit blade correctly (see “Blade
Maintenance”)
Cutting blade not rotating
while machine switched
on
Cutting blade obstructed
Blade nut/bolt loose
Clear obstruction
Tighten blade nut/bolt
Excessive vibration/
noise
Blade nut/bolt loose
Cutting blade damaged
Tighten blade nut/bolt
Replace blade.
F 016 L70 635 • 09.11
F 016 L70 635.book Seite 5 Montag, 2. November 2009 5:23 17