Filter
Top Products
This product is intended for domestic lawn mowing.
This manual gives instructions on the correct as-
sembly and safe use of your machine. It is important
that you read these instructions carefully.
When fully assembled the machine weighs approxi-
mately between 11 and 13.5 kg. If necessary, obtain
assistance to remove from packaging.
Take care when carrying the mower to the lawn, as
the blades are sharp.
Carefully remove the machine from its packaging
and check that you have all the following items:
– Lawnmower with handle assembly
– 1 Handle bottom
– 2 Bolts
– 2 Wing nuts
– 2 Screws
– 2 Grassbox parts (ROTAK 34/36)
– 3 Grassbox parts (ROTAK 40/43)
– 2 Cable clips
– Cable restraint (if supplied separately)
– Operating instructions
When parts are missing or damaged, please contact your
dealer.
1
Switch lever
2
Safety button
3
Handle top
4
Cable restraint**
5
Mains plug**
6
Grassbox
7
Deflector guard
8
Handle bottom
9
Ventilation slots
10
Wheels
11
Grass comb
12
Height of cut lever
13
Serial Number
**Country specific
Not all of the accessories illustrated or described are
included as standard delivery.
Electrical Safety
Your machine is double insulated for safety and re-
quires no earth connection. The operating voltage is
230 V AC, 50 Hz (for non-EU countries 220 V, 240 V
as applicable). Only use approved extension cables.
Contact your service agent for details.
Extension cords/leads should only be used if they
comply with H05VV-F, H05RN-F types or IEC type
design (60227 IEC 53, 60245 IEC 57).
Product Specification
Lawnmower
ROTAK 34 ROTAK 36 ROTAK 40 ROTAK 43
Part number (typ)
3 600 H81 A.. 3 600 H81 B.. 3 600 H81 C.. 3 600 H81 D..
Rated power [W] 1400 1400 1700 1700
Blade width [cm] 34 37 40 43
Height of cut [mm] 20–70 20–70 20–70 20–70
Grassbox capacity [l] 40 40 50 50
Weight (max.) [kg] 11 11.2 13,2 13,5
Protection class
/ II
/ II / II / II
Serial Number
See serial No
13
(rating plate) on machine.
Note: Please observe the order number of your machine. The trade names of individual machines can vary.
Inrush currents cause short-time voltage drops. Under unfavourable power supply conditions, other equipment may be af-
fected. If the system impedance of the power supply is lower than 0.36 Ohm, disturbances are unlikely to occur.
Intended Use
Introduction
Delivered Items
Operating Controls
For Your Safety
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
The blades continue to rotate for a few sec-
onds after the machine is switched off.
Caution - do not touch rotating blades.
F 016 L70 635 • 09.11
F 016 L70 635.book Seite 2 Montag, 2. November 2009 5:23 17