Bolens BL150 Trimmer User Manual


 
HOLDING THE TRIMMER
WARNING: AHways wear eye,
hearing, foot and
body protection to reduce the risk of injury
when operating this unit,
Before operating the unit, stand in the operating position
(Fig. 9). Check for the following:
The operator is wearing eye protection and proper
clothing
With a sHightHy-bentright arm, the operator's right hand
is hoHding the shaft grip
The operator's Heftarm is straight, the Hefthand hoHding
the D-handHe
The unit is at waist HeveH
The cutting attachment is paraHeHto the ground and
easiHycontacts the grass without the need to bend over
BL150
BL100
Fig. 9
ADJUSTING TRiMMiNG LiNE LENGTH
The Bump HeadTM cutting attachment allows you to
release trimming line without stopping the engine. To
release more line, lightly tap the cutting attachment on the
ground (Fig, 10) while operating the trimmer at high speed,
NOTE: Always keep the trimming line fully extended,
Line release becomes more difficult as cutting
line becomes shorter
BL100
Fig. 10
Each time the head is bumped, about 1 inch (25,4 mm)
of trimming line releases, A blade in the cutting
attachment shield will cut the line to the proper length if
any excess line is released,
For best results, tap the bump knob on bare ground or
hard soil, If you attempt a line release in tall grass, the
engine may stall, Always keep the trimming line fully
extended, Line release becomes more difficult when the
cutting line gets shorter,
10
NOTE: Do not rest the Bump HeadTM on the ground
while the unit is running.
personal inJuryor damage to the unit,
Some line breakage will occur from:
Entanglement with foreign matter
Normal line fatigue
Attempting to cut thick, stalky weeds
Forcing the line into objects such as walls or fence posts
TiPS FOR BEST TRiMMiNG RESULTS
Keep the cutting attachment parallel to the ground,
Do not force the cutting attachment, Allow the tip of the
line to do the cutting, especially along walls. Cutting with
more than the tip will reduce cutting efficiency and may
overload the engine,
Cut grass over 8 inches (200 mm) by working from top
to bottom in small increments to avoid premature line
wear or engine drag,
Cut from right to left whenever possible. Cutting to the left
improves the unit's cutting efficiency, Clippings are
thrown away from the operator,
Slowly move the trimmer into and out of the cutting
area at the desired height. Move either in a forward-
backward or side-to-side motion. Cutting shorter
lengths produces the best results,
Trim only when grass and weeds are dry,
The life of your cutting line is dependent upon;
Adherence of the listed trimming techniques
What vegetation is cut
Where vegetation is cut
For example, the line will wear faster when trimming against
a foundation wall as opposed to trimming around a tree,
DECORATIVE TRiMMiNG
Decorative trimming is accomplished by removing all
vegetation around trees, posts, fences, etc,
Rotate the whole unit so that the cutting attachment is at
a 30° angle to the ground (Fig, 11),
BL150
\\
Fig. 11