Filter
Top Products
9
To Engage Augers
1. To engage the augers and start throwing snow,
squeeze the auger control against the handle.
Release to stop the augers.
Engaging the Drive
1. Lifting up on the handle will allow the rubber on the
augers to propel the snow thrower forward. Pushing
downward on the handle will raise the augers off the
ground and stop forward motion.
NOTE: Excessive upward pressure on the handle will
result in premature wear on the rubber auger blades
which would not be covered by warranty.
2. Run the engine for a few minutes before stopping to
help dry any moisture on the engine.
3. Clean the snow thrower thoroughly after each use.
Recoil Starter
MPORTANT: Do not pull the starter handle with engine
running.
WARNING: To avoid unsupervised
engine operation, never leave the
engine unattended while running. Turn
the engine off after use and remove
ignition key.
1. Insert ignition key fully into slot. Make sure it snaps
into place. DO NOT turn ignition key. The engine
cannot start unless the key is inserted into ignition
switch.
2. Move throttle control to FAST (rabbit) position.
3. Move choke to the ON position (cold engine start). If
engine is warm, place choke in OFF position.
4. Push primer three to five (3-5) times, making sure to
cover vent hole when pushing. If engine is warm, push
primer only once. Always cover vent hole when push-
ing. Cool weather may require priming to be repeated.
5. Pull gently on the starter handle until it begins to
resist, then pull quickly and forcefully to overcome the
compression. Do not release the handle and allow it to
snap back. Return rope SLOWLY to original position. If
required, repeat this step.
6. As the engine warms, slowly rotate the choke control
to OFF position. If the engine falters, restart engine
and run with choke at half-choke position for a short
period of time, and then slowly rotate the choke into
OFF position.
Stopping the Engine
WARNING: To avoid unsupervised en-
gine operation, never leave the engine
unattended while running. Turn the
engine off after use and remove ignition
key
Run engine for a few minutes before stopping to help dry
off any moisture on the engine.
1. Move throttle control to STOP position.
2. Remove the ignition key. Removing the key will reduce
the possibility of unauthorized starting of the engine
while equipment is not in use. Keep the key in a safe
place. The engine cannot start without the ignition
key.
3. Wipe all snow and moisture from the area around the
engine as well as the area in and around the drive
control and auger control. Also, engage and release
both controls several times.
IMPORTANT:
For complete and
detailed engine
starting, stopping and
storing instructions,
it is recommended
that you read the
engine manual also
included with
this unit.
NOTE:
Excessive upward
pressure on the
handle will result in
premature wear
on the rubber
auger blades which
would not be covered
by warranty.
5
Operation
Muffler, engine and
surrounding areas
become hot and
can cause a burn.
Do not touch.
WARNING