Filter
Top Products
13
Accessories
Replacement chain and bar are available from your nearest Black &
Decker service center.
Replacement chain # 623382-00
Replacement bar # 623381-00
The use of accessories not recommended in this manual may be
hazardous.
Troubleshooting Section
If your Pole Saw does not operate correctly check the following:
Problem
Possible Cause Possible Solution
• Tool will not
start.
• Unit will not
charge.
• Bar / chain
overheated.
• Battery not
installed properly.
• Battery not
charged.
• Lock-out button not
actuated.
• Pole connections
not properly
tightened.
• Battery not
inserted into
charger.
• Chain too tight.
• Lubrication
needed.
• Check battery installation.
• Check battery charging
requirements.
• Pull back on lock
button/actuate trigger.
• Refer to instruction manual
for pole connections.
• Insert battery into charger
until red LED appears.
Charge up to 8 hours if
battery totally drained.
• Refer to section on
adjusting chain tension.
• Refer to sections for chain
oiling application.
• Chain is
loose.
• Poor cut
quality.
• Chain tension set
incorrectly.
• Chain tension set
incorrectly.
• Chain needs
replacement.
• Refer to section for chain
tensioning.
• Refer to section on
adjusting chain tension.
Note: Excessive tension
leads to excessive wear
and reduction in life of bar
& chain.
Lubricate after every 10
minutes of use.
Refer to section for
installation of chain.
625116-00 NPP2018 Pole 11/12/04 9:11 AM Page 13