Filter
Top Products
6
conditions that may affect their
operation. A guard or other part that is
damaged should be properly repaired
or replaced by an authorized service
center unless otherwise indicated
elsewhere in this manual.
• REPAIRS AND SERVICE. Repairs,
maintenance and any adjustments
not specified in this manual should
be performed by BLACK+DECKER
authorized service centers or other
qualified service organizations, always
using identical replacement parts.
WARNING: Some dust created by
this product contains chemicals known to
the State of California to cause cancer,
birth defects or other reproductive harm.
Some examples of these chemicals are:
•compoundsinfertilizers
•compoundsininsecticides,herbicidesand
pesticides
•arsenicandchromiumfromchemically
treated lumber
To reduce your exposure to these chemi-
cals, wear approved safety equipment
such as dust masks that are specially
designed to filter out
microscopic particles.
• Thelabelonyourtoolmayincludethe
following symbols. The symbols and their
definitions are as follows:
V ..................volts
mW..............milliwatts
nm ...............wavelength in nonometers
A ..................amperes
Hz ................hertz
W .................watts
min ..............minutes
or AC ...... alternating current
or DC ...direct current
n
o ................no load speed
................Class I Construction
(grounded)
................earthing terminal
...............safety alert symbol
................Class II Construction
(double insulated)
.../min or rpm...revolutions or
reciprocation per minute
.................
Use proper respiratory protection
................. Read instruction manual before use
................Use proper eye protection
...................Use proper hearing protection
ASSEMBLY
WARNING: Before assembly, make
sure the bail handle is released and the
mower is unplugged.
ATTACHING LOWER HANDLE
•Lift lower handle (4) into place making
sure the arrow (15) on the base of the
mower lines up with 1 or 2 on the base of
the handle (16) (inset of Figure C)
CAUTION:
Ensure each side of the
lower handle is set on the same number.
The arrow must be lined up with 1 or 2 for
operation.
•Closethe
handle height adjust levers
(6) as shown in Figure C.
As you close
each, make sure the teeth are engaged
as shown in Figure D.
•If the connection between the handle
and lever is too tight or loose, open the
1
5
2
3
6
8
9
10
10
FUNCTIONAL DESCRIPTION
1. Switch box
2. Bail handle
3. Upper-handle
4. Lower-handle
5. Upper-handle attachment levers (2)
6. Lower-handle attachment levers (2)
7. Cut height adjust lever
8. Grass collection bag
9. Rear door cover
10. Carrying handles
11. EdgeMax™
7
4
11