Filter
Top Products
10
CUTTING LINE / LINE FEEDING
Your trimmer uses .065 inch (1.65 mm) diameter, ROUND nylon
line. During use, the tips of the nylon lines will become frayed and
worn and the special self feeding spool will automatically feed and trim
a fresh length of line. DO NOT BUMP unit on ground in attempt to feed
line or for any other purposes. Cutting line will wear faster and require
more feeding if the cutting or edging is done along sidewalks or other
abrasive surfaces or heavier weeds are being cut.
REPLACEMENT ACCESSORIES
CAUTION: Before you begin trimming, only use the appropriate
type of cutting line.
Use BLACK+DECKER replacement spool Model No. AF-100.
Reload nylon line (either bulk or prewound replacement spool) as
shown in this manual.
• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON
MONOFILAMENT LINE. Do not use serrated or heavier gauge
line, as they will overload the motor and cause overheating. This
line is available at your local dealer or authorized service center.
• Other replacement parts (guards, spool caps, etc.) are
available through BLACK+DECKER service centers. To find
your local service location call: 1-800-544-6986 or visit www.
blackanddecker.com.
WARNING: The use of any accessory not recommended by
BLACK+DECKER for use with this tool could be hazardous.
REPLACING THE SPOOL
(FIGURES 12,13,14)
• Remove battery from
tool.
• Depress the tabs (k) and
remove the spool cap (l) from
the spool housing (m) in the
trimmer head (figure 12).
• For best results, replace
spool with BLACK+DECKER
model # AF-100.
• Grasp empty spool with one
hand and spool housing with
other hand and pull spool out.
• If lever (n) (figure 13) in
base of housing becomes
dislodged, replace in correct
position before inserting new
spool into housing.
• Remove any dirt and grass
from the spool and housing.
• Unfasten the end of the
cutting line and guide the line
into the eyelet (o) figure 14.
• Take the new spool and
push it onto the boss (p)
(figure 13) in the housing.
Rotate the spool slightly until it
is seated.
The line should protrude
approximately 5-3/8 inches
(136mm) from the housing.
• Align the tabs on the spool cap with the slots (q) in the housing
(figure 14).
12
Replacement
spool
Model #
AF-100
k
l
k
m
13
n
p