Filter
Top Products
4
This manual contains important safety instructions for battery
chargers.
• Before using charger, read all instructions and cautionary markings
on charger, battery pack, and product using battery pack.
WARNING: Shock hazard. Do not allow any liquid to get
inside charger.
CAUTION: Burn hazard. To reduce the risk of injury, charge
only designated Black & Decker batteries. Other types of batteries
may burst causing personal injury and damage.
• DO NOT OPEN OR MUTILATE the batteries. Released
electrolyte is corrosive and may cause damage to the eyes or skin.
It may be toxic if swallowed.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device mustaccept
any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
. Reorient or relocate the receiving antenna. . Increase the
separation between the equipment and the receiver. Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
The label on your tool may include the following symbols.
V ...............volts A ....................amperes
Hz .............hertz W ...................watts
min ............minutes
..................alternating current
.......... direct current
n
o ................... no load speed
..............
Class II Construction
....................earthing terminal
............. safety alert symbol .../min .............strokes
per minute
COMPONENTS
1
2
3
4
5
7
6
1. LGC120 Cultivator
2. Shroud
3. Tine assembly (x 2)
4. Auxiliary handle
5. Battery pack
6. Lock-off button
7. Switch trigger
Charger (not shown)
IMPORTANT SAFETY INSTRUCTIONS
FOR BATTERY CHARGERS