Filter
Top Products
10
ENGLISH
(Original instructions)
• Place the new saw chain in the groove of the
guide bar and around the sprocket. Make sure
that the teeth are facing the correct direction by
matching the arrow on the saw chain with the
arrow on the housing.
• Make sure that the slot (20) in the guide bar
is over the location pins (21) and that the hole
(22) below the slot is located over the adjust-
ment pin (23).
• Re-t the sprocket cover (5) and the bar clamp
(17) and the screws (16).
• Tighten the screws (16) using the Allen key
provided.
• Adjust the chain tension as described below.
To ensure continued safe operation, the chain
and guide bar must only be replaced with original
Black & Decker parts. Replacement chain part
number A6158 replacement guide bar part number
623381-00.
Checking and adjusting the chain tension
(g. G)
• Check the saw chain tension. The tension is
correct when the saw chain (7) snaps back
after being pulled away 3 mm from the saw
chain bar with light force from the middle nger
and thumb. There should be no ‘sag’ between
the guide bar (6) and the saw chain (7) on the
underside.
To adjust the tension:
• Loosen the screws (16).
• Turn the screw (18) clockwise.
Warning! Do not over-tension the chain as this
will lead to excessive wear and will reduce the
life of the bar and chain.
• Once the chain tension is correct, tighten the
screws (18).
Warning! When the saw chain is new, check the
tension frequently during the rst two hours of
use as a new saw chain stretches slightly.
Oiling the chain
The saw chain must be oiled before each use and
after cleaning using only the correct grade of oil
(cat. no. A6027).
• Oil the whole saw chain (7) evenly using the
applicator (9).
Storage
When the tool will not be used for several months,
ideally leave the battery connected to the charger.
Otherwise proceed as follows:
• Fully charge the battery.
• Remove the battery from the tool.
• Store the tool and battery in a secure and dry
location.
• The storage temperature must always remain in
the range of +10 °C to +40 °C. Place the battery
on a level surface.
• Before using the tool after prolonged storage,
fully charge the battery again.
Protecting the environment
Z
Separate collection. This product must
not be disposed of with normal house-
hold waste.
Should you nd one day that your Black & Decker
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
z
Separate collection of used products
and packaging allows materials to
be recycled and used again. Reuse
of recycled materials helps prevent
environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collec-
tion of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
Black & Decker provides a facility for the collection
and recycling of Black & Decker products once
they have reached the end of their working life. To
take advantage of this service please return your
product to any authorised repair agent who will col-
lect them on our behalf.
You can check the location of your nearest author-
ised repair agent by contacting your local Black
& Decker ofce at the address indicated in this
manual. Alternatively, a list of authorised Black &
Decker repair agents and full details of our after-
sales service and contacts are available on the
Internet at:
www.2helpU.com