Filter
Top Products
9
CONVERT TO EDGING MODE
• To operate as a maintenance edger, turn
the collar (h) as shown in part 1 of figure
11.
• Hold the metal shaft and rotate the lower
housing 180° as shown in part 2.
• Turn the collar (h) until tight.
• If desired, pull the wire edge guide (i) out
from the motor housing until it clicks into
the locked position as shown in figure 12
and position the trimmer above the surface
as shown in figure 12.
• Return to the trimming position by
loosening the lock collar and rotating the
lower housing back 180°. The tool will lock
in the trimmer position. When using the
tool, retract the wire edge
guide to the original position,
out of the way.
CUTTING LINE / LINE FEEDING
Your trimmer uses .065 inch (1.65 mm) diameter, ROUND
nylon line. During use, the tips of the nylon lines will become
frayed and worn and the special self feeding spool will
automatically feed and trim a fresh length of line. Cutting line will
wear faster and require more feeding if the cutting or edging is
done along sidewalks or other abrasive surfaces or heavier
weeds are being cut. The advanced automatic line feeding
mechanism senses when more cutting line is needed and feeds
and trims the correct length of line whenever itʼs required. DO
NOT BUMP unit on ground in attempt to feed line or for any other
purposes.
REPLACEMENT ACCESSORIES
CAUTION: Before you begin trimming, only use the
appropriate type of cutting line.
Use Black & Decker replacement spool Model No. AF-100.
Reload nylon line (either bulk or prewound replacement spool) as
shown in this manual.
• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON
MONOFILAMENT LINE. Do not use serrated or heavier gauge
line, as they will overload the motor and cause overheating. This
line is available at your local dealer or authorized service center.
• Other replacement parts (guards, spool caps, etc.) are available
through Black & Decker service centers. To find your local service
location call: 1-800-544-6986 or visit www.blackanddecker.com.
WARNING: The use of any accessory not recommended by
Black & Decker for use with this tool could be hazardous.
h
11
12
i