Filter
Top Products
9
blade guard to an upward position.
Lower rear of foot plate until blade
teeth almost touch cutting line.
to open freely as you start the cut).
Remove hand from guard lever and
shown in gure 11. Position your body
if it occurs.
cutting surface before starting saw.
saw until its foot plate rests flat on the
material to be cut. Advance saw along
the cutting line until cut is completed as
shown in gure 11.
completely before withdrawing the
blade from
the material.
above.
WRENCH STORAGE (FIG.12)
on the saw shoe as shown in gure 12.
MAINTENANCE
Use only mild soap and damp cloth to
clean the tool. Never let any liquid get
the tool into a liquid.
IMPORTANT: To assure product
SAFETY and RELIABILITY, repairs,
those listed in this manual) should be
performed by authorized service centers
or other qualified service organizations,
always using identical replacement parts.
LUBRICATION
Black & Decker tools are properly
lubricated at the factory and are ready
for use.
ACCESSORIES
Rip fences and other accessories are
location, call: 1-800-544-6986 or visit
www.blackanddecker.com
Recommended accessories for use with
your tool are available from your local
retailer.
WARNING:The use of any accessory not
recommended for use with this tool could be
SERVICE INFORMATION
staffed with trained personnel to provide
customers with efficient and reliable
technical advice, repair, or genuine
factory replacement parts, contact the
To find your local service location,
call: 1-800-544-6986 or visit www.
blackanddecker.com
FULL TWO-YEAR HOME USE
WARRANTY
this product for two years against any
The defective product will be replaced
or repaired at no charge in either of two
ways.
The first, which will result in exchanges
only, is to return the product to the
retailer from whom it was purchased
retailer). Returns should be made within
the time period of the retailer’s policy for
11
8
12