Filter
Top Products
9
TO REMOVE BATTERY PACK:
described above.
Depress the battery release button (17)
on the battery pack and pull battery
pack out of tool as shown in figure D.
BATTERY STORAGE
An extra battery can be stored using the
battery storage compartment (11).
slide the battery into the compartment
as shown in Figure E. Battery in this
compartment will not actuate the mower.
ASSEMBLY
WARNING: Before assembly, make
sure the bail handle is released and the
safety key is removed.
ATTACHING LOWER HANDLE
Lift lower handle (4) into place making
sure the arrow (18) on the base of the
mower lines up with 1, 2, or 3 on the base
of the handle (19) (inset of Figure F)
CAUTION:
Ensure each side of the
lower handle is set on the same number.
The arrow must be lined up with 1, 2, or 3
for operation.
handle height adjust levers
(7) as shown in Figure F.
As you close
each, make sure the teeth are engaged
as shown in Figure G.
If the connection between the handle
and lever is too tight or loose, open the
lever and adjust the depth of the lever
by turning the lever. Close it again until
the teeth are fully clasped and each
lever stays securely closed.
ATTACHING UPPER HANDLE (Figure H)
Remove the upper-handle attachment
levers (5), nuts (20), and washers (21)
from the handle.
upper handle (3) with the holes on the
top of the lower handle (4).
LI-ION Battery Packs and Chargers
This product can accept any of the batteries
and chargers listed in the chart below.
Batteries: LI-ION LBX36
LBXR36
LBXR2036
Chargers: LI-ION LCS36
LCS436
Description Cat. #
D
17
E
H
20
5
21
3
4
G
F
7
4
19
18