Filter
Top Products
ASSEMBLY FOR VACUUM MODE
SHOULDER COLLECTION BAG (FIGURE 4)
•
Attach the shoulder collection bag to the power head as
s
hown in figure 4.
VACUUM TUBE ASSEMBLY (FIGURES 5, 6, 7)
• Vacuum tubes must be assembled together before use.
• Align the notches and the triangles on upper and lower
tubes. (figure 5)
• Push the lower tube firmly into the upper tube, until the
triangles click into place. (Never operate apart).
• In the interest of safety, it is not intended for the tubes to be
separated once assembled.
• Remove the fan cover from the bottom of the power head by
pressing the spring loaded release button (located on the back of
the power head) and pulling the cover off (figure 6).
• Attach the vacuum tube assembly to the power head (figure 7) by
locating the assembly as indicated by arrow, then pivot about this
point until the locking/release catch is fully engaged.
5
4
5
7
6