Black & Decker 479970-00 Lopper User Manual


 
2
Intended use
Your Black & Decker Alligator Lopper
TM
has been designed for
pruning trees and cutting small logs up to 4 inches (100mm) in
diameter. This tool is intended for consumer use only.
General Safety Rules
WARNING: Read all instructions. Failure to follow all instructions
listed below may result in electric shock, fire and/or serious injury.
WARNING: To reduce the risk of injury, user must read
instruction manual.
SAVE THESE INSTRUCTIONS.
1. Work area
a. Keep work area clean and well lit. Cluttered and dark areas
invite accidents.
b. Do not operate power tools in explosive atmospheres, such
as in the presence of flammable liquids, gases or dust. Power
tools create sparks which may ignite the dust or fumes.
c. Keep children and bystanders away while operating a power
tool. Distractions can cause you to lose control.
2. Electrical safety
a. Power tool plugs must match the outlet. Never modify the
plug in any way. Do not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs and matching outlets
will reduce risk of electric shock.
b. Avoid body contact with earthed or grounded surfaces such
as pipes, radiators, ranges, refrigerators and wire fences. There
is an increased risk of electric shock if your body is earthed or
grounded.
c. Do not expose power tools to rain, damp or wet conditions.
Water entering a power tool will increase the risk of electric shock.
Don’t use in rain.
d. Do not abuse the cord. Never use the cord for carrying,
pulling or unplugging the power tool. Keep cord away from
heat, oil, sharp edges or moving parts. Damaged or entangled
cords increase the risk of electric shock.
e. When operating a power tool outdoors, use an extension
cord suitable for outdoor use. Use of a cord suitable for outdoor
use reduces the risk of electric shock.
f. Ground Fault Circuit Interrupter (GFCI) protection should be
provided on the circuit(s) or outlet(s) to be used for the
gardening appliance. Receptacles are available having built-in
GFCI protection and may be used for this measure of safety.
3. Personal safety
a. Before you start the saw, make sure the saw chain is not
contacting anything. Stay alert, watch what you are doing and
use common sense when operating a power tool. Do not use a
power tool while you are tired or under the influence of drugs,
alcohol or medication. A moment of inattention while operating
power tools may result in serious personal injury.
b. Use safety equipment. Always wear eye protection. Safety
equipment such as dust mask, non-skid safety shoes, hard hat,
rubber gloves, snug-fitting clothing or hearing protection used for
appropriate conditions will reduce personal injuries.
c. Avoid accidental starting. Ensure the switch is in the off
position before plugging in. Carrying power tools with your finger
on the switch or plugging in power tools that have the switch on
invites accidents.
d. Remove any adjusting key or wrench before turning the
power tool on. A wrench or a key left attached to a rotating part of
the power tool may result in personal injury.
e. Do not overreach. Keep proper footing and balance at all
times. This enables better control of the power tool in unexpected
situations.
f. Dress properly. Do not wear loose clothing or jewellery. Keep
479970-00 LP1000 9/14/05 1:00 PM Page 2