Filter
Top Products
Part No. 890394 Form No. F011398B
Page 7 of 12
Before turning machine off, use the Tamper to slowly push
remaining pieces of wood through the chipper. This can
prevent any remaining wood from jamming in the chipper
when machine is turned off.
Do not leave tamper on the ground, store tamper in the
chipper hopper.
Using two people to lift machine is recommended. Lift holding the
handle and front of nozzle. Secure in place during transport.
Never store engine indoors or in enclosed poorly venti-
lated areas with fuel in tank, where fuel fumes may reach an
open flame, spark or pilot light, as on a furnace, water heater,
clothes dryer or other gas appliance.
If engine is to be unused for 30 days or more, prepare as
follows:
Be sure engine is cool. Do not smoke. Remove all
gasoline from carburetor and fuel tank to prevent gum deposits
from forming on these parts and causing possible malfunction
of engine. Drain fuel outdoors, into an approved container,
away from open flame. Run engine until fuel tank is empty
and engine runs out of gasoline.
NOTE: Fuel stabilizer (such as Sta-Bil) is an acceptable
alternative in minimizing the formation of fuel gum deposits
during storage. Add stabilizer to gasoline in fuel tank or
storage container. Always follow mix ratio found on stabilizer
container. Run engine at least 10 min. after adding stabilizer to
allow it to reach the carburetor.
Do not store with debris in bag.
16.516.5
16.516.5
16.5
OPERATION continued
TAMPER
16.16.
16.16.
16.
1212
1212
12
1616
1616
16
HANDLING & TRANSPORTING:
STORAGE
16.416.4
16.416.4
16.4
Tamper Storage Position (SP model shown).