Filter
Top Products
Part No. 510153 Form No. F102802D
Never store engine indoors or in enclosed poorly
ventilated areas with fuel in tank, where fuel fumes
may reach an open flame, spark or pilot light, as on a
furnace, water heater, clothes dryer or other gas appliance.
If engine is to be unused for 30 days or more, prepare
as follows:
Be sure engine is cool. Do not smoke. Remove all gasoline
from carburetor and fuel tank to prevent gum deposits from
forming on these parts and causing possible malfunction of
engine. Drain fuel outdoors, into an approved container, away
from open fl ame. Run engine until fuel tank is empty and engine
runs out of gasoline.
Using two people to lift machine is recommended. Lift holding the
handle and front of deck. Secure in place during transport.
NOTE: Fuel stabilizer (such as Sta-Bil) is an acceptable
alternative in minimizing the formation of fuel gum deposits
during storage. Add stabilizer to gasoline in fuel tank or
storage container. Always follow mix ratio found on stabilizer
container. Run engine at least 10 min. after adding stabilizer
to allow it to reach the carburetor.
CAUTION: Wheels must be chocked or blocked when
unit is parked on a slope.
HANDLING & TRANSPORTING:
16.6
STORAGE
16.7
16
16.5
HILLSIDE MOWING
HILL
WARNING! Never mow on any slope greater than 15 degrees.
Always mow across the face of slopes; never up and down or
diagonally see fig 5.1). DO NOT attempt sudden starts or stop when
mowing on a slope. Avoid Sudden turns and use extreme cauton when
changing direction on a slope.
Fig. 5.1
OPERATION continued
Page 7 of 12
Use only a qualifi ed mechanic for
any adjustments, disassembly or any
kind of repair .
WARNING: TO AVOID PERSONAL
INJURY, ALWAYS TURN MACHINE OFF,
MAKE SURE ALL MOVING PARTS COME
TO A COMPLETE STOP.
17
MAINTENANCE
RECONNECT SPARK PLUG WIRE,
AND ALL GUARDS BEFORE STARTING
ENGINE.
DISCONNECT SPARK PLUG WIRE
BEFORE SERVICING UNIT.
Note: Blade, and drive belts are normal wear items.
These should be inspected on a regular basis and
replaced if worn.
ENGINE
When servicing engine refer to specifi c manufacturers engine owner's
manual. All engine warranty is covered by the specifi c engine manufacturer.
If your engine requires warranty or other repair work contact your local
servicing engine dealer. When contacting a dealer for service it is a good
idea to have your engine model number available for reference(See table
page 11). If you can not locate a servicing dealer in your area you can
contact the manufacturers national service organization.
To reach:
Briggs & Stratton: 800-233-3723
Engine (See Engine Manual)
Check for excessive vibration
Inspect for loose parts
Maintenance Operation
Follow these hourly maintenance
intervals.
Maintenance Schedule
Inspect for worn/damaged parts
Every
Use
Every 50
hrs
Every 5 hrs
or (Daily)
Every 25
hrs
Sharpen Blade
Inspect belts for wear
Replace blade and traction belts
MAINTENANCE HISTORY
Service Performed
Date of Service
Every
100-150 hrs
Lubricate height adjustment
pins
Lubricate front wheels