Filter
Top Products
VS0102 / VS0104 / VS0108 User Manual
8
Installation
Single Stage
Installation of the VS0102 / VS0104 / VS0108 is simply a matter of plugging
in the appropriate cables.
To install the splitter, refer to the installation diagram on page 10 as you
perform the following steps:
1. Use a VGA/Audio cables to connect the VGA/Audio output ports on the
source device to the VGA/Audio input ports on the VS0102 / VS0104 /
VS0108.
2. Use VGA/Audio cables to connect the VGA/Audio inputs of the video
displays and speaker devices to the VGA/Audio output ports on the rear of
the VS0102 / VS0104 / VS0108.
3. Use a grounding wire to ground the unit by connecting one end of the wire
to the grounding terminal, and the other end of the wire to a suitable
grounded object.
4. Plug the provided power adapter into an appropriate AC power source;
plug the power adapter cable into the power jack on the VS0102 / VS0104
/ VS0108.
5. (Optional) To control the VS0102 / VS0104 / VS0108 system through the
RS-232 port, connect the hardware/software controller here.
The installation is complete, you may power on the display and source devices.
Note: The VS0102 / VS0104 / VS0108 installations are the same, with the only
difference being that the VS0102 has two video display ports, the VS0104 has
four video display ports, and the VS0108 has eight video display ports.