Filter
Top Products
Chapter 3. Operation
19
Verification
After entering a command, a verification message appears at the end of the
command line as follows:
command ok- indicates that the command is correct and successfully
performed by the switch
command incorrect - indicates that the command has the wrong format
and/or values.
Powering Off and Restarting
If you power off the VS0102 / VS0104 / VS0108, follows these steps before
powering it on again:
1. Power off the attached devices.
2. Unplug the power adapter cable from the VS0102 / VS0104 / VS0108.
3. Wait 10 seconds, and then plug the power adapter cable back in.
After the VS0102 / VS0104 / VS0108 is powered on, power on the attached
devices.