Filter
Top Products
English - 5
GB • Printed in England • BA F 016 L69 839 • QX elctric • OSW 02.02
The mower is fitted with a QX (quick exchange)
cassette which can be removed and taken to
Approved Service Agent for sharpening. To re-
move the cassette:
It is advisable to wear a pair of gardening
gloves (not supplied).
Remove grassbox cradle 11.
Remove the drive cover 20 by removing
screws 21.
Remove cassette retaining screws 22 on both
sides.
Remove pulley 23 and belt 24 by removing
3 screws 25.
Pull the cutting cassette unit 26 out using the
handle. Obtain assistance if required.
Replace the cassette and fit retaining
screws 22.
Slacken the idler pulley screw 28.
Refit the pulley 23 and belt 24.
Adjust the idler pulley 27 against the belt 24 and
tighten idler pulley screw 28.
Refit the drive cover 20.
This method is the same for fitting or removing
cassette accessories.
If the mower doesn’t drive adequately it may
be necessary to adjust the drive cable as follow:
Slacken nut 29, turn adjuster 30 a few turns anti-
clockwise.
Retighten nut 29.
When correctly adjusted, drive to the rear roller
is engaged when the drive control lever 17 is
squeezed against the handle top 1 or disen-
gaged when released.
Clean the exterior of the machine thoroughly
using a soft brush and cloth. Do not use water,
solvents or polishes. Remove all grass and de-
bris, especially from the ventilation slots 8.
Turn the machine on its side and clean the
blade area. If grass cuttings are compacted in
the blade area, remove with a wooden or plas-
tic implement.
Store the lawnmower in a dry place. Do not
place other objects on top of the machine. To
save space, fold up the handle fully.
☞
Ensure cables are not trapped when
folding/unfolding top handles, do not
drop the handles.
Removing/replacing
QX Cylinder Cassette
B G H
Adjusting Drive Cable (self
propelled models only)
After Mowing/Storage
G
F016 L69 839.book Seite 5 Freitag, 22. Februar 2002 10:04 10
17 • F016 L69 839 • TMS • 05.02.02