Filter
Top Products
13
7) After your spa is operational you must install the Spa
Cover latches. The locks will already be attached to the end
of the straps. Position the tie strap so it is fully extended,
without stretching. Locate the 2 holes on the locking mecha-
nism, marking them with a pen. Remove the locking mecha-
nism from the strap and fasten to the spa.
SP
SP
A
A
OPERA
OPERA
TIONS GUIDE
TIONS GUIDE
T
T
opside Contr
opside Contr
ol Component Identification
ol Component Identification
T
T
opside Indicator Icons
opside Indicator Icons
Pump Light Filter Heat Temperature
Heat
Heat
and Heat buttons
and Heat buttons
The spa’s thermostat is to provide you with optimum control
of the spa water temperature. This temperature set point can
be adjusted from 15°C (40°F) to 40°C (104°F).
Note: if you have a blower button on the topside digital control pad
then you will only have one button for heat up and heat down. By
holding the heat button down for 3 seconds you can either heat up
or heat down. Press the heat button again for 3 seconds to do the
opposite.
HAZARD
Never leave an uncovered spa unattended,
and never leave a covered spa unlatched.
➔
➔