Filter
Top Products
12
INITIAL ST
INITIAL ST
ART
ART
-UP
-UP
Before proceeding with the initial start-up, make sure you
have completed the start-up preparations from the previous
section. The following procedures must be done in the order
they are listed.
1. Make sure all of the jets are in the full open position, (refer
to Hydrotherapy Jets, page 13).
2. The Electronic Operating System spa control has
automatic functions that operate upon start-up and normal
operation to protect the system.
3. With the breaker in the “On” position check to see if water
is circulating and pump is running. If not then you must turn
the power off to prime the pump. To prime the pump turn
union #1 slowly 1/2 to 1 turn to release air, being careful not
to open too far. If you are sure that you have released the air
lock, retighten the union and turn the power on. The pump
must be primed every time the water is changed. Check to
see if water is coming from all the jets.
4) Press the pump button on the control panel to test if the
pump is changing from low to high-speed, (refer to
Topside Control Component Identification, next page).
You will be able to tell the difference between low and
high-speed by the sound of the water moving through the
spa’s plumbing system. Press the pump button again to
return the pump to low speed.
5) Once the water has reached the set temperature add chem-
icals to adjust the water balance (see Chemical Maintenance,
page 19).
6) If you experience any problems with the procedures above
contact an Aruba customer service representative.
WARNING
Only turn union one turn
counter clockwise.
HAZARD
This system should be set to maintain
a water temperature NO GREATER THAN
40° CELSIUS (104° F).