Filter
Top Products
13
Pump button
Pump button
The control panel button designated “PUMP” activates the
pump when pressed. The pump sequence is low speed, high
speed, off. The pump, when the “PUMP” button is manual-
ly pressed, turns off after thirty minutes (a thirty-minute
default).
NOTE: You will not be able to turn off your pump if your spa is in
a filter cycle, heating, or in freeze protection (less than 52°F).
Light
Light
The control panel button designated “LIGHT” activates the
spa light when pressed. The light turns off after two hour (a
two-hour default).
Filter Cycle Pr
Filter Cycle Pr
ogramming
ogramming
Proper filtration is an important key to maintaining the clar-
ity of your spa’s water. The filter system is designed for
unsurpassed effectiveness at removing debris and suspen-
sions from the water while the water is circulating.
By pressing the Heat key and the Program key at the same
time, you can adjust your filtration cycle from the factory set-
ting of 2 hours every 12 hours, in 1-hour intervals.
NOTE: If the water temperature does not drop the internal timer
still operates the filter cycle to ensure proper filtration.
CELSIUS OR FAHRENHEIT
By pressing the Program key and the Light key at the same
time you can change the degree settings from Celsius to
Fahrenheit or vise versa.
AIR CONTROLS
There are two air controls beside the topside control panel.
By turning these controls you may adjust the amount of air
going to the jets. When fully open you are getting the maxi-
mum amount of air for full hydrotherapy action. To reduce
the amount of air coming out of the jets simply close the air
controls.