Filter
Top Products
1 Install a left roof panel at the left
rear and right front corner of the roof.
Install a right roof panel at the left
front corner of the roof.
3 Install 4 roof panels in the se-
quence and positions shown on pre-
vious page.
Do not fasten the lower
end of the panels to the side wall
angles at this time.
Continue weather
stripping the ridge opening. Fasten
roof panel overlaps not used for ridge
cap (roof center). Cover the head of
bolt with the 2" (5cm) piece of weather
stripping tape.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
Step 14
B27
● Parts Needed For ●
Roof Assembly
27
●●
●●
● 8467 Left Roof Panel (2)
●●
●●
● 7875 Roof Panel (4)
●●
●●
● 8466 Right Roof Panel (1)
2 Cut 2 short 2" (5cm) strips off the
roll of weather stripping tape, and
put them aside. Cover the joint at the
peak with weather stripping tape.
Unroll the tape and press it down
over the opening at the ridge as you
install each roof panel. Do not cut the
tape at this time.
NOTE
If roof beam holes do not line up
with the roof panel holes, shift the
building from left to right.
If this does not help, your building
may not be level. Shim the
corners until holes line up.
FRONT
Do not fasten
at this time
Cut
Weather Stripping
and Fold Under
FRONT
Fasten At
Overlap with
Bolt
7875 Roof Panel
Fasten At
Overlap with
Bolt
Screws To
Roof Beam
Weather Stripping
Tape Roll
8467 Left Roof Panel
STEP
2
STEP
Strips
STEP
Screws To
Roof Beam
8466 Right
Roof Panel
1
3