Filter
Top Products
21
●●
●●
● 6515 Wall Panel (4)
●●
●●
● 6243 Wall Panel (2)
● Parts Needed For ●
Wall Panels
Step 8
P21
The wall panels come in two widths.
Each wall panel has a crimped rib on
one side. The crimped rib should go
under the rib of the panel that follows
it.
1 Locate all of the wall panels and
set each one alongside the building.
2 Be sure that you have the correct
panels in each position. Do this by
overlapping the panels and deter-
mining if the holes line up with the
holes in the frame.
3 Fasten the wall panels at the top
and bottom with screws.
4 Fasten the center of each panel to
the wall channel with screws. Fasten
overlapping ribs using a bolt and nut
with two screws.
5 When you have attached all wall
panels in the correct positions, the
building will look like this.
STEP
2
6243
Panels rest on
frame as shown
6243
6515
6515
6515
6515
Crimped Rib
Underneath
Detail Showing
Center of Panel
Screwed to
Wall Channel
Bolt and nut
does not go thru
wall channel
at overlap
STEP
4
STEP
3
Use bolts and
nuts thru wall
angle overlap
at the top of
panel at rear.
STEP
5
STEP
1