Filter
Top Products
1 Install a left roof panel at the left
rear and right front corner of the roof.
Install a right roof panel at the left
front corner of the roof.
3 Install 2 narrow and 2 wide roof
panels in the sequence and posi-
tions shown on previous page.
Do
not fasten the lower end of the panels
to the side wall angles at this time.
Continue weather stripping the ridge
opening.
4 Install the first ridge cap on the
completed roof section using bolts
and nuts. Fasten roof panel overlaps
not used for ridge cap. Cover the
head of bolt with the 2" (5cm) piece of
weather stripping tape. Do not fasten
the ends of the ridge cap at this time.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
Step 15
Y28
● Parts Needed For ●
Roof Assembly
28
●●
●●
● 8468 Right Roof Panel (1)
●●
●●
● 8469 Left Roof Panel (2)
●●
●●
● 7483 Roof Panel (2)
●●
●●
● 6529 Roof Panel (2)
●●
●●
● 8840 Ridge Cap (1)
2 Cut 4 short 2" (5cm) strips off the
roll of weather stripping tape, and
put them aside. Cover the joint at the
peak with weather stripping tape.
Unroll the tape and press it down
over the opening at the ridge as you
install each roof panel. Do not cut the
tape at this time.
NOTE
If roof beam holes do not line up
with the roof panel holes, shift the
building from left to right.
If this does not help, your building
may not be level. Shim the
corners until holes line up.
Do not fasten
at this time
FRONT
Fasten At
Overlap with
Bolt
6529 Roof Panel
Fasten At
Overlap with
Bolt
Screws To Roof Beam
Weather Stripping
Tape Roll
8469 Left Roof Panel
STEP
2
STEP
8840
STEP
Screws To
Roof Beam
6529 Roof Panel
1
3
STEP
4
7483 Roof Panel
7483 Roof Panel
8468 Right
Roof Panel