Filter
Top Products
GB - 21
2. Drive shear bolt through hole (if shear bolt
was broken this will drive remaining part
from shaft).
3. Secure shear bolt with nut.
SPEED SELECTOR ADJUSTMENT
To adjust (Figure 15):
1. Remove hair pin from adjustment pivot
pin.
2. Pull shift rod and adjustment pivot pin out
of speed selector lever.
3. Place the speed selector lever in the
fastest forward speed position.
4. Pull the shift rod straight down towards
the ground as far as it will go.
5. Thread the adjustment pivot pin along the
shift rod until it aligns with the mating hole
on the speed selector lever.
6. Reinsert the pivot pin into the hole on the
speed selector lever.
7. Check forward and reverse speeds.
a. Start unit.
b. Shift speed selector into first forward
speed.
c. Engage traction clutch. Unit should
move forward.
d. Stop unit.
e. Shift speed selector into first reverse
speed.
f. Engage traction clutch. Unit should
move backward.
g. Shut off unit.
8. Adjust pivot pin as needed so unit travels
forward when speed selector lever is in
first forward position and backward when
speed selector lever is in first reverse
position.
9. Secure adjustment pivot pin to speed
selector lever with hairpin.
Figure 14
1. Auger
2. Shear Bolt(s)
3. Roll Pin
1
3
2
OS0402
Figure 15
1. Shift Rod
2. Adjustment Pivot Pin
3. Speed Selector Lever
4. Hair Pin
OSs0195
1
2
3
4