Filter
Top Products
GB - 12
Tools Required:
• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
• Tire Gauge
ASSEMBLY
Unfold Handlebar (Figure 4)
1. Loosen wing knobs and release J-bolts
from lower handlebar.
2. Unfold upper handlebar and align
handlebar holes.
3. Put J-bolts through the upper handlebar
and lower handlebar holes.
4. Tighten wing knobs to secure upper
handlebar.
Install Discharge Chute and Chute
Crank (Figure 5, 6, and 7)
NOTE: See Figure 5 for the items to install on
the unit.
1. Grease chute seat (if not already
greased).
2. Remove hardware (and chute crank
support bracket on models 932037 & 505)
from top of engine (Figure 6).
3. Install discharge chute by positioning the
chute ring under retainer clip on seat
support.
4. Install chute support bracket (and chute
crank support bracket on models 932037
& 505) to engine with hardware removed
in step 2.
5. Loosen mounting nut on chute bracket
and move discharge chute up or down
until chute ring is centered between
retainer clip and chute seat. Tighten
hardware (Figure 7).
6. Slide chute crank through support
bracket.
7. Install chute crank to pinion with spring
clip.
ASSEMBLY
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Dropping or tipping over
boxed unit could result in personal
injury or damage to unit.
Figure 4
1. Wing Knob
2. J-Bolt
3. Lower Handlebar
4. Upper Handlebar
1
OS3000
2
4
3
Figure 5
OS3500
3
2
1
1. Discharge Chute
2. Spring Clip
3. Chute Crank
4. Pinion
4