Filter
Top Products
GB - 24
6. Reinstall the bearing cap/bushing on the right
side of frame.
7. Reinstall roll pins in shaft. Be sure pins are
centered in shaft.
8. Connect the pivot pin to the speed selector arm
with the hardware removed in step 6 of Remove
Friction Disc on page 23
9. Reinstall tires with lockpins.
10. Install bottom cover.
11. Set unit upright.
12. Connect spark plug wire to spark plug.
SHORT TERM
IMPORTANT: NEVER spray unit with high pressure
water or store unit outdoors.
Run with attachment clutch engaged a few minutes
after each use to free unit of any loose or melting snow.
Close fuel shut-off valve.
Inspect unit for visible signs of wear, breakage or
damage.
Keep all nuts, bolts and screws properly tightened and
know unit is in safe working condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low pressure
water and lubricate (see Maintenance). Touch up all
scratched painted surfaces.
Remove weight from wheels by putting blocks under
frame or axle.
When storing unit for extended periods of time, remove
all fuel from tank and carburetor (run dry). Refer to
Engine Manual.
To obtain a complete parts manual, find your model
and serial number. Then go to www.ariens.com or call
1-920-756-4664.
STORAGE
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
SERVICE PARTS
Order the following parts through your Dealer:
Part No. Description
00036800 Stens Mix Hi-Temp Grease (3, 3 oz.
cartridges)
21533400 Spark Plug (932040, 140)
21533500 Spark Plug (932041, 042, 141, 509, 510,
511)
07219100 Impeller Belt
07210600 Traction Belt (932040, 140)
07210700 Traction Belt (932041, 042, 141, 509, 510,
511)
53200500 Shear Bolts
03248300 Friction Disc
ACCESSORIES
See your authorized Ariens dealer to add the additional
accessories available to your Sno-Thro.
Part No. Description
73203100 Slicer Bar*
72200600 120 Volt Starter Kit
73202500 240 Volt Starter Kit*
72406500 Front Weight Kit*
*Available in CE countries.