Filter
Top Products
GB - 12
CONTROLS AND FEATURES
See Figure 7 for all Controls and Features locations.
Traction Drive Clutch - Left Hand Lever
Squeeze the Traction Drive Clutch
Lever against the Handlebar (1) to
engage wheel drive for propelling
unit. Forward speed will vary
according to snow depth and
moisture content.
Release lever (2) to stop movement.
NOTE: When traveling to or from the
area to be cleared, press down on the handlebars
enough to raise the front of the unit slightly off the
surface. Engage the traction drive clutch without
engaging the attachment drive clutch.
Attachment Clutch - Right Hand Lever
Squeeze Attachment Clutch Lever
against handlebar (1) to engage
attachment. Release both clutch
levers (2) to disengage power and
apply brake to attachment.
IMPORTANT: If the belt squeals
when the attachment clutch lever is
engaged, the impeller may be frozen
in the auger housing. Immediately
release the attachment clutch lever and move the unit
into a heated area to thaw.
NOTE: If belt squeals when impeller turns freely, see
Attachment Drive Belt Replacement on page 19.
Ignition Switch (120V start on engine)
Key Switch has two positions:
1. “Stop” - pulled out
2. "Run" - pushed in
NOTE: DO NOT twist key after it is
inserted.
Primer Bulb
Pushing the primer bulb in adds fuel for
easier engine start. Refer to Starting and
Shut Off on page 14.
Speed Selector
Position the Speed Selector in the appropriate speed
notch to control forward and reverse travel.
Forward:
(6) Fastest
(1) Slowest
Reverse:
(1) Slow
(2) Fast
IMPORTANT: DO NOT change motion from forward to
reverse with clutch engaged. Forward speed can be
changed without declutching.
Choke Control Knob
1. Choke Closed position: chokes off
air to engine for easier start.
2. Choke Open position: allows for
normal operation.
IMPORTANT: Gradually open choke
after engine starts.
Throttle
The throttle controls the engine speed. To
increase or decrease the engine speed,
adjust to:
1. Fast (normal or warm starts)
2. Part-Throttle
3. Slow (cold weather starts)
4. Stop (engine is off) (Not on 12V models)
Electric Starter (120V electric start models)
The electric starter will start a properly choked and
cranked engine when the starter button is pushed.
Refer to Starting and Shut Off on page 14.
Recoil Starter Handle
When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back against
starter.
OPERATION
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
WARNING: To avoid injury to hands and feet,
always disengage clutches, shut off engine,
and wait for all movement to stop before
unclogging or working on snow thrower.
Keep hands and feet away from auger and
impeller.
1
2
OL2701
1
2
OL2691
1
2
OS1431
OS1321
OS2401
65432
1
1
2
1
2
OS1332
STOP
1
2
3
4
OL2720