Filter
Top Products
GB - 25
If chute does not rotate freely:
Tighten the cable by loosening the upper adjustment
nut, and then tightening the lower adjustment nut
against the bracket (Figure 29).
SPEED SELECTOR ADJUSTMENT
To adjust (Figure 30):
1. Place unit into service position.
2. Disconnect adjustment pivot pin from speed
selector lever.
3. Place the speed selector in the fastest forward
speed position.
4. Turn the speed selector lever straight down
towards the ground as far as it will go.
5. Thread the adjustment pivot pin along the shift
rod until it aligns with the mating hole on the
speed selector lever. Insert the pivot pin into hole.
6. Secure adjustment pivot pin with hairpin.
7. Make sure the speed selector shifts into each
speed position.
ATTACHMENT CLUTCH/BRAKE
ADJUSTMENT
(Figures 31, 32 and 33)
1. Measure spring extension.
a. Measure the length of the clutch cable spring.
b. While holding the attachment clutch lever
against the handlebar, measure the length of
the spring again. The spring should be
1/2-11/16 in. (12.7-17.5 mm) longer when the
lever is engaged.
Loosen upper
adjustment nut.
Tighten lower
adjustment nut.
Figure 29
OS7180
IMPORTANT: IMPROPER ADJUSTMENT
could result in unexpected movement of
auger and impeller causing death or serious
injury. Auger / impeller must stop within 5
seconds when Attachment Clutch/Impeller
Brake lever is released.
Figure 30
1. Shift Rod
2.Adjustment Pivot Pin
3. Speed Selector Lever
4. Hairpin
2
3
1
4
OS7185