Filter
Top Products
GB - 14
Choke Control Knob
1. Choke Closed position: chokes off air to engine for
easier start.
2. Choke Open position: allows for normal operation.
IMPORTANT: Gradually open choke after engine
starts.
Throttle
The throttle controls the engine speed. To increase or
decrease the engine speed, adjust to:
1. Fast (normal or warm starts)
2. Part-Throttle
3. Slow (cold weather starts)
4. Stop (engine is off) (Not on 12V models)
Electric Starter
The electric starter will start a properly choked and
cranked engine when the key is turned (12V) or starter
button (120V) is pushed. Refer to Starting and Shut Off
on page 17.
Recoil Starter Handle
When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back against
starter.
Snow Clean-Out Tool (Figure 12)
To clear the discharge chute:
1. Shut off the engine.
2. Wait 10 seconds and make sure impeller blades
have stopped rotating.
3. Remove the snow clean-out tool (1) from the
auger housing and use it to remove the clog from
the discharge chute.
4. Replace the snow clean-out tool on the auger
housing.
Deflector Remote
Place deflector into position before operation. DO NOT
throw snow any higher than necessary.
Place deflector remote in a forward notch to throw
snow lower. Place deflector remote in a rearward notch
to throw snow higher.
Discharge Chute
Discharge chute rotates 200°.
ALWAYS position discharge chute in safe direction and
angle, away from operator and bystanders, before
starting engine.
2
1
1
2
926001, 002, 003,
013, 016, 500, 501
926014, 015
926001, 002, 003,
013, 016, 500, 501
926014, 015
4
3
2
1
4321
WARNING: Hand contact with the rotating
impeller is the most common cause of injury
associated with snow throwers. Never use
your hand to clean out the discharge chute.
1
Figure 12
OS7100