Filter
Top Products
GB - 14
Timer (TMR1): measures the time spent on
individual jobs.
Press and hold the toggle button to reset the
timer to zero. TMR1 will then start measuring
engine run time until it is reset to zero again.
Service Alert (Chg Oil, Chg H Oil & Filter,
SVC Airfilter): reminds operators of the
maintenance interval for changing the engine
oil, changing the hydraulic oil and filter and
servicing the air filter.
The alert starts counting down two hours
before the maintenance is due. The meter
flashes the word, "Now," when it reaches the
maintenance time.
Press and hold the toggle button to reset the
maintenance clock to zero after perfoming
the service.
NOTE: The hour meter is preprogrammed for
the initial oil change at 25 hours and for 100
hours thereafter. The hour meter is
programmed for the initial hydraulic oil and
filter change at 75hours and for 400 hours
thereafter.
Steering Levers
• Reverse (1) – Pull both steering levers
backward.
• Forward (2) – Push both steering levers
forward.
• Left (3) – Pull left steering lever back or
push right steering lever forward or a
combination of both.
• Right (4) – Pull right steering lever back
or push left steering lever forward or a
combination of both.
NOTE: To stop, return both steering levers to
neutral.
NOTE: The steering levers must be in the
neutral position to start the engine.
NOTE: The parking brake must be
disengaged prior to moving the steering
levers from the neutral position.
Mower Lift Pedal (Figure 6)
Raises and lowers the deck.
NOTE: The adjustment pin is used to set the
height of the mower deck. See
SPECIFICATIONS on page 30 for cutting
height dimensions.
Press mower lift pedal and install adjustment
pin in the desired adjustment hole.
NOTE: Adjusting the seat
further forward will help
increase the leverage in
lifting the mower deck (see
Adjusting Seat on
page 15).
Display
Toggle Button
1
2
3
4
Figure 6
1. Adjustment Pin
2. Mower Lift Pedal
3. Adjustment Hole
1
3
2
02988000
7
08088400A