Filter
Top Products
GB - 24
REPLACING HYDROSTATIC BELT
Remove (Figure 16)
1. Remove PTO belt (see REPLACING
PTO BELT on page 23).
2. Disconnect Electric Clutch Connector
from PTO.
3. Disconnect idler spring.
4. Remove hydrostatic belt from
hydrostatic transmission pulleys, pulley,
electric clutch, and idler.
Install (Figure 16)
1. Install hydrostatic belt on idler, electric
clutch, pulley, and hydrostatic
transmission pulleys.
2. Connect idler spring.
3. Connect electric clutch connector.
4. Install PTO belt (see REPLACING PTO
BELT on page 23).
CAUTION: Use care when
releasing idler spring tension.
Keep body parts well away from
idler when performing this
operation.
Figure 16
1
1. Hydrostatic Belt
2. Hydrostatic
Transmission
Pulley
3. Idler
4. Idler Spring
2
2
3
4